Contact
    Start Publications Effects of mono/hybrid nanofluid strategies and surfactants on ...
    ←  Publication Finder
    Attension

    Effects of mono/hybrid nanofluid strategies and surfactants on machining performance in the drilling of Hastelloy X

    Year: 2021

    Journal: Tribol. Int., Volume 157, MAY

    Authors: Sirin, Emine; Kivak, Turgay; Yildirim, Cagri Vakkas

    Organizations: Erciyes University Research Fund [FBA-2019-8834]

    Keywords: Hastelloy X; Drilling performance; Mono and hybrid nanofluids; Hole quality; Surfactants

    This study examined the effects of dry, base fluid, mono and hybrid nanofluid cooling/lubrication conditions on machining performance in drilling of nickel based Hastelloy X superalloys. Nanofluids were prepared by adding 0.6 vol% graphene nanoplatelets (GNP) and/or hexagonal boron nitride (hBN) with or without addition of 0.25 wt% sodium dodecyl sulfate (SDS) and/or gum arabic (GA) as surfactants into the cutting lubricant. Drilling experiment were performed at two different cutting speeds (20 and 30 m/min), two different feed rates (0.04 and 0.06 mm/rev) and a constant drilling depth (13.5 mm). Cutting force, hole quality (surface roughness and de-viations in diameter, circularity and cylindricity), cutting temperature, burr height, tool wear and tool life were selected as the performance criteria. The best results with regard to cutting force, hole quality, burr height, and tool wear were obtained under SDS added hBN/GNP hybrid cutting, whereas the best results for cutting tem-perature were achieved under hBN/GNP hybrid cutting condition without surfactants. In terms of tool wear, after 10 holes under dry cutting, flank wear on the drill was measured as 0.281 mm, whereas after 60 holes under hBN/GNP-SDS cutting condition, it was measured as 0.135 mm. This indicated a 51.96% improvement in tool wear compared to dry cutting. Among the mono nanofluids, the hBN-SDS cutting condition delivered the best performance, whereas among the hybrid nanofluids, the hBN/GNP-SDS cutting performed the best. Finally, evaluation of the surfactants added to the nanofluids revealed that SDS surpassed GA in terms of machining performance.
    View publication