Contact
    Start Publications Effects of Subphase pH and Temperature on the Aggregation ...
    ←  Publication Finder
    KSV NIMA

    Effects of Subphase pH and Temperature on the Aggregation Behavior of Poly(lauryl acrylate)-block-poly(N-isopropylacrylamide) at the Air/Water Interface

    Year: 2019

    Journal: J. Phys. Chem. C, Volume 123, APR 25, page 10435–10442

    Authors: You, Kun; Wen, Gangyao; Skandalis, Athanasios; Pispas, Stergios; Yang, Shicheng; Li, Hongfei; Sun, Zhaoyan

    Organizations: Open Research Fund of State Key Laboratory of Polymer Physics and Chemistry, Changchun Institute of Applied Chemistry, Chinese Academy of Sciences; Natural Science Fund of Heilongjiang ProvinceNatural Science Foundation of Heilongjiang Province [B2015023]

    Effects of subphase pH and temperature on the aggregation behavior of a thermosensitive amphiphilic diblock copolymer poly(lauryl acrylate)-block-poly(N-isopropylacrylamide) (PLA-b-PNIPAM) at the air/water interface and the morphologies of its Langmuir-Blodgett (LB) films were characterized with the Langmuir film balance technique and atomic force microscopy, respectively. The surface pressure-molecular area isotherms shift positively with the increase of subphase pH, and there exist two quasi-plateaus under acidic condition but only one under neutral or alkaline conditions. The lower and upper plateaus under acidic condition are attributed to immersion into water for the protonated amide groups and the rest of PNIPAM blocks, respectively. The plateau pressures gradually decrease with the elevation of temperature due to promotion of protonation and solubility of PNIPAM blocks. On the contrary, those under neutral and alkaline conditions gradually increase but exhibit a lower critical solution temperature behavior which is consistent with that of PNIPAM-containing polymers in aqueous solutions. The initial LB films of PLA-b-PNIPAM transferred from different subphases exhibit tiny isolated circular micelles which coalesce and transform into large dense ones upon compression. Furthermore, PLA cores usually coalesce with the elevation of temperature due to the increased molecular thermal mobility as a result of their low glass transition temperature.
    View publication