Contact
    Start Publications pH-Controlled assembly of polyelectrolyte layers on silica ...
    ←  Publication Finder
    QSense

    pH-Controlled assembly of polyelectrolyte layers on silica nanoparticles in concentrated suspension

    Year: 2022

    Journal: J. Colloid Interface Sci., Volume 615, JUN, page 265–272

    Authors: Kolman, Krzysztof; Poggi, Giovanna; Baglioni, Michele; Chelazzi, David; Baglioni, Piero; Persson, Michael; Holmberg, Krister; Bordes, Romain

    Organizations: European Union's Horizon 2020 research and innovation programme under the NanoRestArt project [646063]

    Keywords: Silica; Nanoparticle; Polyelectrolyte; Polyelectrolyte layers; Controlled assembly; Adsorption; Aggregation; Concentrated suspension

    Hypothesis: Preparation of suspensions of nanoparticles (>1 wt%) coated with a polyelectrolyte multilayers is a challenging task because of the risk of flocculation when a polyelectrolyte is added to a suspension of oppositely charged nanoparticles. This situation can be avoided if the charge density of the polymers and particles is controlled during mixing so as to separate mixing and adsorption events. Experiments: The cationic polyethylenimine (PEI) and the anionic carboxymethylcellulose (CMC) were used as weak polyelectrolytes. Polyelectrolyte multilayers build-up was conducted by reducing the charge of one of the components during the addition of the next component. Charge density was controlled by tuning pH. Analysis of the suspension of coated nanoparticles was done by means of dynamic light scattering, electrophoresis and small angle x-ray scattering measurements, while quartz crystal microbalance was used to study the build-up process on flat silica surfaces. Findings: Charge density, controlled through pH, can be used as a tool to avoid flocculation during layerby-layer deposition of polyelectrolytes on 20 nm silica particles at high concentration (-40 wt%). When added to silica at pH 3, PEI did not induce flocculation. Adsorption was triggered by raising the pH to 11, pH at which CMC could be added. The pH was then lowered to 3. The process was repeated, and up to five polyelectrolyte layers were deposited on concentrated silica nanoparticles while inducing minimal aggregation.
    View publication