Contact
    Start Publications Stable increased formulation atomization using a multi-tip ...
    ←  Publication Finder
    Attension

    Stable increased formulation atomization using a multi-tip nozzle device

    Year: 2018

    Journal: Drug Deliv. Transl. Res., Volume 8, DEC, page 1815–1827

    Authors: Haj-Ahmad, Rita; Rasekh, Manoochehr; Nazari, Kazem; Onaiwu, Ekhoerose V.; Yousef, Bushra; Morgan, Stuart; Evans, David; Chang, Ming-Wei; Hall, John; Samwell, Chris; Ahmad, Zeeshan

    Organizations: EPSRC EHDA Network; Royal Society (Industrial Fellowship)

    Keywords: Multi-tip emitter (MTE); Electrospraying; Nanoparticles; Microparticles; Jetting; Electrohydrodynamic; Encapsulation

    Electrohydrodynamic atomization (EHDA) is an emerging technique for the production of micron and nano-scaled particles. The process often involves Taylor cone enablement, which results in a fine spray yielding formulated droplets, which then undergo drying during deposition. In this work, novel multi-tip emitter (MTE) devices were designed, engineered and utilized for potential up-scaled EHDA, by comparison with a conventional single-needle system. To demonstrate this, the active ketoprofen (KETO) was formulated using polyvinylpyrrolidone (PVP) polymer as the matrix material. Here, PVP polymer (5% w/v) solution was prepared using ethanol and distilled water (80:20) as the vehicle. KETO was incorporated as 5% w/w of PVP. Physical properties of resulting solutions (viscosity, electrical conductivity, density and surface tension) were obtained. Formulations were electrosprayed through both single and novel MTEs under EHDA conditions at various flow rates (5-300l/min) and applied voltages (0-30kV). The atomization process using MTEs and single nozzle was monitored at using various process parameters via a digital optical camera. Resulting particles were collected 200mm below processing heads and were analyzed using differential scanning calorimetry (DSC), thermal gravimetric analysis (TGA), X-ray diffraction (XRD) and scanning electron microscopy (SEM). Digital recordings confirmed stable MTE jetting at higher flow rates. Electron micrographs confirmed particle size variation arising due to nozzle head design and evidenced stable jetting derived greater near-uniform particles. DSC, XRD and TGA confirm KETO molecules were encapsulated and dispersed into PVP polymer particles. In conclusion, novel MTE devices enabled stable atomization even at higher flow rates when compared to conventional single-needle device. This indicates an exciting approach for scaling up (EHDA) in contrast to current efforts focusing on multiple-nozzle and pore-based processing outlets.
    View publication