Contact
    Start Surface Science Blog
    Close

    Share page

    Email LinkedIn Twitter Facebook

    Surface Science Blog You have only scratched the surface.

    Susanna Laurén

    Susanna Laurén

    Susanna is an Application Scientist at Biolin Scientific. In her PhD thesis, she developed fabrication methods for a new type of inorganic-organic polymers. Microfabricated polymer chips were utilized as tool for biomolecule separation in analytical chemistry.

    Find me on:

    < 4 min

    How to deposit graphene oxide thin films?

    Graphene oxide is hydrophilic and thus dispersible to water. Dispersibility makes the solution-based deposition of graphene oxide possible.

    < 3 min

    What is required for good adhesion?

    Good adhesion is generally required whenever a coating is applied to a surface. A clean surface and good wettability are needed for good adhesion.

    ~ 2 min

    Nanoparticle coating techniques: Comparison of spin coating and Langmuir-Blodgett deposition

    Spin coating is one of the most used thin-film coating technique and for this reason, any new technique is typically compared to it.

    ~ 3 min

    What is adhesion?

    Adhesion is the attraction between two dissimilar phases. It is commonly divided into mechanical interlocking and physical and chemical bonding.

    ~ 2 min

    Evaluation of functional coatings

    More and more research interest is being put on functional coatings. New measurement techniques are required to evaluate them.

    > 3 min

    Wettability determines the adhesion of coatings

    Coatings are typically evaluated by methods such as laboratory drawdown. Contact angle measurement can provide a more quantitative approach.

    ~ 2 min

    Optimize the level of additives in coating formulation with surface tension measurements

    A basic requirement of any coating is that it should form a uniform, defect-free surface. Surface and interfacial tensions play a key role in that.

    < 3 min

    How to measure contact angle hysteresis and roll-off angle by tilting method?

    Contact angle hysteresis is often measured with so-called tilting cradle or plate method. The measurement can be done either manually or automatically.

    > 2 min

    Automated dynamic contact angle measurement with the needle method

    Dynamic contact angle measurements with the needle method has been automated for reliable and repeatable results.

    Explore the blog

    You have only scratched the surface.

    Popular

    Topics

    View all

    Authors

    View all

    Archive

    View all